Articles
MiniMax H3 Image: Show Where the Name Will Go
Share article
“Put the name on the front” sounds clear until you start making the apron. You mean high on the chest. The customer means just above the pocket. They have approved the spelling and font, but the position is still a guess.
Give them two views before production. With MiniMax H3 Image, you can try both placements on your own apron photo and use the comparison to agree on a direction.
Make the Difference Easy to See
Start with a straight-on photo of the actual apron. Keep the neckline, pocket, and seams visible so the customer has clear points of reference.
Use the sample name ALEX in both previews.
-
A: centred high on the chest, closer to the neckline.
-
B: centred immediately above the pocket.
Keep the lettering size, font, and colour the same. Explain that ALEX is a placeholder for choosing the position. The customer’s actual name goes into the production proof.
Try Both Placements in MiniMax H3 Image
Upload the photo in Image Edit. For option A, try this prompt:
Use the uploaded apron photo as the reference. Add ALEX in simple cream block lettering, centred high on the chest, closer to the neckline than the pocket. Preserve the fabric colour, apron shape, straps, pocket, and seams.
For option B, start again from the original photo. Keep the text instruction and change the placement to “centred immediately above the pocket.”
Compare both results with the source photo. Check the spelling, pocket position, seams, and apron outline. If the lettering sizes differ, match them in a design editor before sending. If an edit changes the garment, return to the original photo and add the placement in a design editor.
Label the previews A and B, then send them together with one question:
“Would you like the name high on the chest, as in A, or just above the pocket, as in B?”
If the customer replies “a little higher,” ask them to mark the spot on the image.
Confirm the Actual Name and Measurements
Once the customer chooses a position, replace ALEX with their exact name in the production proof. A longer name may reach closer to a seam or extend beyond the pocket width. Check the full name at the intended lettering size before asking for approval.
Give the maker a clear measurement to follow. For A, show the distance from the neckline to the top edge of the lettering. For B, show the gap between the bottom edge of the lettering and the pocket’s top edge. Include the units and centre alignment.
Name the proof and refer to it in the confirmation message:
Please confirm Apron B-v2, including the name, lettering size, and position measurements shown in the attached proof.
Save the approved proof with the order so the customer and maker can refer to the same placement.